Specifications
Dimension of test bar Height: 14 mm - 24 mm Width: 20 mm Length: min. 60 mm to determine S, min. 100 mm to determine E
Weight EW 220: 6,5 kg BK 230: 5,4 kg
Tool Dimension EW…
Bending Crawling Expansion Device BK 230
The device allows the same measurements as the EW 220, but in addition to the investigation of bending crawling expansion of plastics. Into the bending…
Tiedemann offers an extensive product range in the field of photoelasticity, ranges from polarisation films with different degrees of polarization, retardation films to device types with different…
Calibration and Renovation of Dynamometer
According to DIN 51301, the testing certificate is valid for 24 months only. Therefore, it is recommended to recalibrate the device after this period. …
Load Frame with Large Model Kit
The stresses in the components can be ideally demonstrated through this load frame placed in a polariscope. Tensile, compressive and bending forces can be applied. …
Specifications
Load frame Mechanical load frame for tension forces
Tension measurement analog ring dynamometer 10 kN
Models 5 models (without a notch, with a circular hole with…
Calibration The calibration of the dynamometers with a maximum load up to 100 kN is done with force measuring equipment at Tiedemann. The accuracy of our calibration device is certified periodically…
Calibration Table The determination of the calibration values (10 steady steps from zero to the maximum load) occurs according to the internal testing method following DIN 51301 (increasing and…
